- One Project Closer - http://www.oneprojectcloser.com -

Fred & Kim’s Basement, Part 1

Posted By Ethan On February 19, 2013 @ 7:00 am In Basement,Pro Follow | 15 Comments

Between traveling and coordinating schedules, our Pro-Follows have slowed down a little so I’m glad to finally be back on a job site with Joe Bianco. We’re kicking off another Pro-Follow series, and this basement should look familiar because it’s Fred and Kim’s basement. This is where we produced our spray foam insulation [1] video and several other articles. You may be thinking that we’ve already covered a lot of basement projects and this Pro-Follow won’t offer anything new. Well think again because some of the exciting aspects of this remodel include flashing an existing deck, mold detection/ remediation and a comprehensive guide for installing a heated floor.

If you’re new to our Pro-Follows, Joe is a professional contractor and president of SDG Home Solutions [2]. I shadow Joe on actual job sites, and there’s no better way to learn about home improvement than straight from an experienced contractor. I’d encourage you to check out some of the other work Joe has completed (basement remodel [3]kitchen remodel [4]bathroom remodel [5]). If learning from the pros sounds interesting to you, subscribe to our email [6] or RSS [7] feed and never miss an update.

DSC_0002

As you can see, most of the framing has been completed, and the electric has been run. Just about the entire basement is insulated with closed-cell foam, and I think it’s worth mentioning that closed-cell foam is an excellent insulation option, albeit more expensive than traditional fiberglass batts. This closed-cell foam provides an R-value of 7.5 per inch, and forms a complete vapor barrier.

DSC_0003

Fred installed over 1,000 sq. ft. of electric radiant heat and embedded the wires in self-leveling mortar (SLM) throughout the entire basement. Look for a comprehensive guide detailing the entire process of installing radiant heat flooring including laying tile to come out of this Pro-Follow.

DSC_0011

Electric

Most of the electric work was already finished. However, there were a few minor changes and additions that needed to take place, and Joe brought in Russel from ETC Electric to tackle the short list. Russel added some boxes and switches for track lighting.

DSC_0001

He also took care of odds-n-ends like junctioning these wires in a box, and making sure everything else was tidy and up to code.

DSC_0010

Plumbing

There wasn’t much plumbing work required since the finished basement won’t include a bathroom or any other plumbing fixtures. Joe brought in a plumber from Drain Relief to relocate a few valves, replaces some hose bibs and run a new line for the refrigerator water supply.

DSC_0017

Framing

The framers didn’t have too much rough framing to complete either. Joe had them frame around a bulkhead, frame in support poles, ensure drywall nailers in all the corners and frame around some plumbing.

They started by putting down a temporary floor protection called Ram Board to better protect the floors (and heating element).

DSC_0002

Here’s a few shots of the guys framing the bulkheads.

DSC_0005

DSC_0009

DSC_0010

DSC_0013

A few of the floor joists had a serious crown, and the previous owners (or a contractor they hired) “fixed” that by simply cutting the joists. If you’re at all familiar with framing, you know that’s not an acceptable solution. To remedy that, these joists have a 2 x 10 through-bolted to them. Unfortunately, they are not all even so the framers planed the floor joists as necessary for drywall.

DSC_0008

More to Come

Some of the work still to come includes blocking up three small windows.

DSC_0007

The contractor who built Fred and Kim’s deck did not properly flash the ledger board. This is something Fred and Kim discovered when they found water leaking into their basement! Fred used silicone as a temporary solution, and now Joe will be flashing the existing deck to make sure it never leaks again. Look for a detailed how-to after that work takes place.

DSC_0012

Joe will also be replacing this sliding glass door.

DSC_0013

That’s it for this update. Next time, you’ll get a look at mold detection, and it was fascinating! I hope you’ll stick with me.


Article printed from One Project Closer: http://www.oneprojectcloser.com

URL to article: http://www.oneprojectcloser.com/basement-remodel/

URLs in this post:

[1] spray foam insulation: http://www.oneprojectcloser.com/installing-spray-foam-insulation-video/

[2] SDG Home Solutions: http://sdghomesolutions.com

[3] basement remodel: http://www.oneprojectcloser.com/back-in-the-basement-remodel-completed/

[4] kitchen remodel: http://www.oneprojectcloser.com/total-kitchen-remodel-completed/

[5] bathroom remodel: http://www.oneprojectcloser.com/triple-bathroom-remodel-completed/

[6] email: http://feedburner.google.com/fb/a/mailverify?uri=OneProjectCloser

[7] RSS: http://www.oneprojectcloser.comfeed://feeds.feedburner.com/OneProjectCloser?format=xml

Copyright © 2011 One Project Closer. All rights reserved.